Broadcast SRC-8 III Guide de l'utilisateur télécharger pdf (Page 84)

74 Chapter 7: Configuration

7.8.5 Video Disk Control Protocol (VDCP)

Figure 16: Video Disk Control Protocol

The Video Disk Control Protocol (VDCP) configuration allows a VDCP connection

for the Media Sequencer to be established in order to externally control a Viz

Content Pilot playlist or Viz Trio show.

With VDCP the Media Sequencer acts like a server that controls the graphics

through the VDCP protocol. It sets up a serial connection, and on the other end of

the connection typically a video controller is placed. Over this connection VDCP

commands are sent, and in this way the video controller is able to control the

playlist/show.

The configuration of the Media Sequencer is twofold. There are the general VDCP

settings, and there is the configuration for which playlist to control.

The VDCP protocol defines recommended serial settings, but if you for some

reason need to use different settings please refer to the Media Sequencer

manual’s VDCP section, and in particular the section on "Electrical and Mechanical

Specifications", for information on how to configure this.

This section contains information on the following topic:

• Properties and Parameters

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 246 247

Pas de commentaire

Broadcast SRC-8 III Guide de l'utilisateur Page 84