Broadcast SRC-32 Manuel d'utilisateur télécharger pdf (Page 12)

LOGGER CONFIGURATION

Once the VCP software is installed (see previous driver setup),

configuring Logger is relatively simple. Start the Logger application

and from the top left corner, click on “Configure” then “Hardware”.

You should see the following display.

Enable the SRC 32 device as the input codes are the same as the GPI

32 and select the appropriate COM port. You will need to restart your

Logger application once you have saved your configuration settings.

Under “Feeds” from the main Logger display, select the feed you wish

to apply closure and configure under “Input Closures” and select the

SRC 32 device from the drop down list of closure devices available.

Verify you are receiving all closures through the “Event Log” tab form

the Logger main display. From the top left corner of the main Logger

display, select “Tools’ then “Configure” and enable all events Logging

from the “Administration” tab.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

Broadcast SRC-32 Manuel d'utilisateur Page 12